|
THE
EVAPORATOR COIL
It
is important to clean the evaporator coil inside the
AHU. This helps to prevent the condensation from the
evaporator coil and accumulated dust from becoming a
breeding ground for bacteria and viruses. A better filtration
system will also help to keep the evaporator coil clean
for a longer duration. Bravo Series Detachable EAC Filter
will meet this requirement.
FEATURES
OF ELECTRONIC CELL
The
cells consist of 2 stages of design: first the 8.2kVDC
will charge up the tungsten wire to create high voltage
with positive (+) charge for “dirty air”
to pass through them; it continue to travel to the 2nd
stage of a group of 4.1kVDC collection plate and a group
of earth plate (-); the “dirty air” will
then all charge up with positive (+) and negative (-)
charge and trap to each other like magnet on to the
opposite charge collecting plate. Only “clean
air” will pass through these 2 stages and go back
to the environment, the above process will recur again
and again.
FEATURES
OF HIGH VOLTAGE POWER PACK
The
AC Power, supply to high voltage power pack will filter
to DC voltage by bridge rectifier, and pass through
primary winding of transformer in designated frequency.
Then secondary winding produce 4kV alternating current,
according to its turn’s ratio. This voltage is
supplied through voltage double circuit and doubled
up to required voltage of electronic cells. That helps
to maintain constant out put voltage and current, the
output voltage and current is controlled by self regulated
processor and high voltage power pack will not produce
output current more than 5mA under any circumstances.
|
